problem with 06 impala SS tire monitor system?

Question by Pa: problem with 06 impala SS tire monitor system?

I have an 06 Impala SS and my right rear tire pressure isn’t coming up on the screen and it keeps saying “service tire monitor system” is there anything i can do to fix this problem?

Best answer:

Answer by giff01
Sounds like the tpm sensor in the rr wheel is no good,take it to your gm dealer & have them chk it out.most likely the sensor..Good luck

Give your answer to this question below!

Please read other answers to this question at the very bottom of this page, below you will find a video and related articles that will try to answer the question, if you have a proper answer please post it at the bottom.

Installation video for the EverSmiling Wireless Tire Pressure Monitoring System (TPMS). An aftermarket product, the TPMS delivers real time tire pressure and temperature information to the driver of the vehicle. The United States published the TREAD Act in 2000, mandating the use of TPM technology in order to alert drivers of a severe under-inflation condition of their tires.

Video Rating: 0 / 5

Tire Pressure Monitoring System helps to keep your vehicle running smooth

Tire Pressure Monitoring System is usually referred to as TPMS. As the name suggest, it helps in monitoring the pressure inside the tires of the vehicle. Tire pressure Monitoring System is located in all the vehicles that carry heavy load such as forklifts, airplane undercarriages, etc.

Tire Pressure Monitoring System is basically divided into two. One is direct TPMS and the other is indirect TPMS. This division is based on the functioning of the Tire Pressure Monitoring System.

Direct Tire Pressure Monitoring System uses radio frequency technology for transferring pressure information to the driver. In direct TPMS, pressure sensors are located on the sides of the tires. Pressure transducers in the vehicle transfer the pressure information and report to the driver about the over inflation and under inflation of the tires. The major disadvantage of Direct Tire Presser Monitoring System is that it uses the battery which is very expensive.

In contrast to this, Indirect Tire Pressure Monitor System operates on different principle. This system estimates the amount of air in the tires and informs the driver about it. The number of the rotations tire takes and the speed with which it rotates decide whether the tire is under inflated or over inflated. If the tire is taking smaller rounds and is rotating faster than it means that the tires are not inflated properly i.e. they are under inflated. On the other hand, if the tires are taking more time to rotate then the tires are over inflated. So, the tires rotating at appropriate speed and taking particular number of rotations determines the pressure in the tires. The major disadvantage of this system is that the driver need to press reset button over again to know the status of the tires (if the tires are properly inflated or not).

Earlier, Tire Pressure Monitoring System was placed in the tires to ensure the safety of the vehicle; however the newer models come with this system. This system by informing and maintaining appropriate air pressure helps the tires to work at its full potential.

<input id=”gwProxy” type=”hidden” /><input id=”jsProxy”>

The appropriate pressure in the tires is very important for the smooth running of your vehicle. Now days, cars come installed with Tire Pressure Monitoring System that keeps the driver informed about the air pressure in the tires. Sometimes when the pressure in the tires is low, it beeps the warning light that stays turned on even if the tire has been repaired. To repair this fault, many auto repair shops have the right auto specialty tool to deal with this. Here comes a Tire Pressure Monitoring System tool that helps in repairing this fault.

Tire Pressure Monitoring System is divided into two systems: Direct Tire Monitoring System and Indirect Tire Monitoring System. Though the functionality of the two is same but the manner of detecting the air pressure is quite different. In Direct Tire Pressure Monitoring System, the sensors are placed in the wheels that measure the exact amount of air pressure in the tires. The major disadvantage of this system is that it works on battery which is quite expensive. Apart from that, once the sensors stop functioning, you have to replace it with a new one. So, always take necessary precautions while changing the tires of your vehicle.

On the other hands, Indirect Tire Pressure Monitoring System does not have sensors in the wheel.  They make use of anti lock brake wheel speed to check the status of air pressure in the wheel. The speed of the tire and the number of rotations made by tire in a specific time helps to estimate whether the tire is under inflated or over inflated. The sensors in the wheel notice the variation in the speed of the tire and display the warning.

Before 2008, the vehicles were not installed with Tire Pressure Monitoring System. However, later this system start coming installed with the vehicles to ensure complete safety.

<input id=”gwProxy” type=”hidden” /><input id=”jsProxy”>

More Tire Pressure Monitoring System Articles